Jump to content

You're browsing the 2004-2023 VATSIM Forums archive. All content is preserved in a read-only fashion.
For the latest forum posts, please visit https://forum.vatsim.net.

Need to find something? Use the Google search below.

Frequency.


Thomas Leirikh 1191516
 Share

Recommended Posts

Thomas Leirikh 1191516
Posted
Posted

Hi,

When i did some circuits an ATC join and told me to change the frequency,

But his freq' was 199.00.

The highest is 134.99...what i need to do?

Thanks,

Thomas.

Link to comment
Share on other sites

David Baker 1004102
Posted
Posted

Most likely the controller had not primed his frequency in his controller client. I'd reply via chat what you see as his frequency and advise that you can't tune it.

ZMP_BD

MITRE OP1 survivor

Link to comment
Share on other sites

Thomas Leirikh 1191516
Posted
Posted
Most likely the controller had not primed his frequency in his controller client. I'd reply via chat what you see as his frequency and advise that you can't tune it.

 

report in the Unicom?(122.80).

thanks.

Link to comment
Share on other sites

Brian Cheung 1181193
Posted
Posted

Or send him a private message using .msg [iD] blah blah blah

 

for example

 

.msg DC_CTR I can't tune to 199.998.

Brian Cheung - 1181193

ZDC

1181193.jpg

Link to comment
Share on other sites

Thomas Leirikh 1191516
Posted
Posted
Or send him a private message using .msg [iD] blah blah blah

 

for example

 

.msg DC_CTR I can't tune to 199.998.

 

where is the privet msg?

Link to comment
Share on other sites

Keith Smith
Posted
Posted

Thomas,

 

Review the brief docomeentation that came with the software. It explains how to bring up the command window (ENTER) to be able to send private messages.

 

It's likely at the controller said "frequency change approved." If the listed frequency for a controller is 199.998, then you cannot tune them on the radio and should essentially pretend that they don't exist at that point.

Link to comment
Share on other sites

 Share