Sebastien Bartosz Posted September 27, 2021 at 10:51 PM Posted September 27, 2021 at 10:51 PM Hi there, I tried looking everywhere and was wondering if there was a way to set the active airports with a simple alias command? Thanks New York ARTCC Link to comment Share on other sites More sharing options...
Andreas Fuchs Posted September 28, 2021 at 09:13 AM Posted September 28, 2021 at 09:13 AM Not sure, but what I am doing is save certain airport/runway-configurations and then rename them for future use. For example I set all my airports/runways for standard Westerly operations, then I save the profile and close Euroscope. As a result I will get a file called xxxx.rwy. I then copy and rename it for example as "WesterlyOps.rwy". I do the same for Easterly Ops and whatever is needed. I then just have to remember to copy/paste the contents before starting Euroscope. It may seem a bit complicated, but it is still quicker than going through the "active runways dialogue" in Euroscope. With a little bit of knowledge one can create a .BAT-file to speed up even this process. Cheers, Andreas Member of VATSIM GermanyMy real flying on InstagramMy Twitch streams of VATSIM flights and ATC Link to comment Share on other sites More sharing options...
Sebastien Bartosz Posted September 29, 2021 at 12:26 AM Author Posted September 29, 2021 at 12:26 AM Thanks Andreas, I like that - I may give it a try! New York ARTCC Link to comment Share on other sites More sharing options...
Recommended Posts