By James Crisp 1377989
#517090 Hey so I made the switch to P3D V4, finally got it all setup and getting back into controlling, I load up Euroscope with no major issues, load up P3D V4, Load into Tower Controller View, then load vPilot (All as Administrator), type the .towerview command into vPilot, it says connected as an observer, but nothing appears in my P3D client, I do .aircraft to see if it's doing anything it's not registering any aircraft to load.

I'm kinda stuck between is this a Euroscope issue, that it's not telling vPilot the information it needs (the proxy server is running), a vPilot issue where it's not reading properly, or just that it can't inject traffic into P3D V4 using the towerview command (model matching works correctly when flying normally).
By Evan Reiter 1314720
#517607 James,

I'm not familiar with EuroScope, but Ross' latest vSTARS client has the capability to use vPilot in proxy mode to connect a virtual tower view using Prepar3D or FSX. Was this what you were looking for? Or does EuroScope also work with vPilot to achieve the same thing?
By Morten Jelle 1012739
#517612 You need to open ES and start a proxy connection, to get connected as observer using the .towerview command. However, it sounds like, you are not using the latest version of Euroscope.