- Sun Jan 21, 2018 10:59 pm #521046 Greetings,

Euroscope doesn't show up the display settings boxes to toggle what is displayed.


If I disable one of the boxes, the box disappears! The VORs and Fixes and all that should be set up properly.

Thanks in advance.

Ray Trac

- Wed Jan 24, 2018 7:52 pm #521117 Hi Ray,

I don't think it is setup correctly, because then I would have been shown. But have you entered this stuff in the ESE file or SCT file?
If I remember correctly, this data comes from the ESE file.

Morten Jelle
VATEUD Deputy Division Director | Senior Divisional Instructor [I3] | VATSIM Network Supervisor

- Thu Jan 25, 2018 12:46 am #521123 Morten,

It is all set up in the .sct file. I am 90% sure it goes in the .ese file.

Sincerely,
Ray Trac

Ray Trac

- Fri Jan 26, 2018 11:15 pm #521157 Just to be sure, it is not automatically going into the ESE file. So if it isn't in the ESE file, it must be entered into that one.

Morten Jelle
VATEUD Deputy Division Director | Senior Divisional Instructor [I3] | VATSIM Network Supervisor

- Sat Jan 27, 2018 2:50 am #521160 Morten,

It should be going to the ese file. I can see the things if I go and edit the profile display settings to show a group. I just don’t want to type every single item to be displayed.

Sincerely,
Ray Trac

Ray Trac