Jim Cvitkovic 918392 Posted October 28, 2005 at 01:57 PM Posted October 28, 2005 at 01:57 PM Ok, first, I'm new to this all over again. It's been several years since I've used SB. I remember being able to see aircraft in the area. I've set the limit to 250. It's also set on to use FSUIPC or something like that instead of FS aircraft. Now, when I'm in an area, I don't see any planes at all, even ones that are near to me. So, I've decided to fly into EGLL hoping I'll see something. Any suggestions? And yes, I've read the forum but maybe I missed something. -jim Link to comment Share on other sites More sharing options...
Nicholas Bartolotta 912967 Posted October 28, 2005 at 03:51 PM Posted October 28, 2005 at 03:51 PM Are you sure there was even traffic in the area you were flying? I suggest getting a friend to be at the same airport your at (arrange a time), and then see if you can see him sitting at the gate. Don't pick a huge airport like EGLL, where you can get lost...pick a smaller airport like EGUN, this way you can definetly find him if he is there. Once you've done that, you'll know a little more info, which can end up being a lot of help Nick Bartolotta - ZSE Instructor, pilot at large "Just fly it on down to within a inch of the runway and let it drop in from there." - Capt. Don Lanham, ATA Airlines Link to comment Share on other sites More sharing options...
Recommended Posts