Freek Vandeursen 1101105 Posted April 13, 2011 at 08:46 PM Posted April 13, 2011 at 08:46 PM I have a dual monitor setup, running my main screen (CTR) on 1 screen and 2 other instances of Euroscope (APP & GND) via the proxy server on the 2nd screen. In my APP screen I set an altitude filter, so that high altitude traffic is not shown as it is not relevant there. However, when I [Mod - Happy Thoughts]ume the track of an aircraft, it is still shown in my APP screen, despite the altitude filter. Is there a way to change this? Link to comment Share on other sites More sharing options...
Stephan Boerner 945550 Posted April 13, 2011 at 08:50 PM Posted April 13, 2011 at 08:50 PM I don't think so, no. The filter only works with untracked targets. Stephan Boerner VATEUD - ATC Training Director EuroScope Board of Designers | GVCCS Beta Tester EuroScope Quick Start Guide Link to comment Share on other sites More sharing options...
Freek Vandeursen 1101105 Posted April 14, 2011 at 11:42 AM Author Posted April 14, 2011 at 11:42 AM I thought so. Thanks for the quick answer. Maybe a feature request for some future version? Link to comment Share on other sites More sharing options...
Stephan Boerner 945550 Posted April 14, 2011 at 11:54 AM Posted April 14, 2011 at 11:54 AM Not sure if that would make sense. What do you want to use that for? As soon as you have an aircraft under control, you need to see it. Of course you might have a different screen for APP like you have in your setup, I have one too in my EDGG setup, but overflying traffic is usually no issue for the much smaller APP airspace. Yes, sometimes an overflying aircraft crosses the lateral boundaries of the APP airspace and is therefore visible on the screen, but that is usually just for a very short time. Anyway this would have to be an option and not a general change in behaviour of the filters. Stephan Boerner VATEUD - ATC Training Director EuroScope Board of Designers | GVCCS Beta Tester EuroScope Quick Start Guide Link to comment Share on other sites More sharing options...
Jonas Eberle Posted April 14, 2011 at 12:44 PM Posted April 14, 2011 at 12:44 PM I do also think it would not make much sense. And it would be an option prone to be wrong-used. If you climb or descent an [Mod - Happy Thoughts]umed aircraft through your altitude filter and it suddenly disappears: Wouldn't you think it must have disconnected? I think such option would lead to problems. Link to comment Share on other sites More sharing options...
Freek Vandeursen 1101105 Posted April 14, 2011 at 09:54 PM Author Posted April 14, 2011 at 09:54 PM Yes I see it can lead to problems, especially when using only a single screen. I asked it specially for my dual screen setup as some overflights can be very annoying in a busy APP sector. But well, it would be only applicable for a few situations, too few for implementation probably. Link to comment Share on other sites More sharing options...
David Saunders 818672 Posted April 15, 2011 at 12:27 PM Posted April 15, 2011 at 12:27 PM start another ASR and then press F7 that way you can have filters on but can switch between APP and upperairspace as required non-discript self importance signature Link to comment Share on other sites More sharing options...
Freek Vandeursen 1101105 Posted April 15, 2011 at 08:40 PM Author Posted April 15, 2011 at 08:40 PM Wouldn't that have the same problem David? tracked aircraft are displayed regardless of altitude filters. Link to comment Share on other sites More sharing options...
Recommended Posts