Mahmoud Fadli 819693 Posted August 3, 2011 at 06:33 AM Posted August 3, 2011 at 06:33 AM Hello Everyone, I currently have FS2004 and the Project Airbus A321. I've been working on trying to merge the aircraft with the WILCO Feelthere A321 IAE Panel and I'm having some problems. I've done merges before, and the A318/A319/A320 merges went fine (even did CJElite merges for the A318 with no problem). The A321, however, is another issue and I'm having a hard time trying to figure it out. I've searched the net to try and find something helpful, but so far I've come up with nothing. Specifically, my issue with the PA A321/WILCO FT Panel Merge has to do with the stabilizer trim. The aircraft's trim is overly sensitive, and it seems like the autoflight system is trying to compensate for the aircraft's tendency to pitch up by applying a lot of nose down trim. I've attached a screenshot below of the issue. Any ideas what can be causing this? I played around with the trim_effectiveness section but to no avail. Note that the screenshot was taken as the aircraft was pitching up to climb on autopilot. The other issue I have is with the engine spool up time. It takes almost twice as long to spool up to take off power (both on FLEX and TOGA) than on the A319/A320. I understand that there might be slight differences between the A319/A320/A321 engine options, but I don't think that results in increased spooling times between the three types. Any suggestions would be appreciated. Mahmoud A. Fadli - 819693 Deputy Region Director VATSIM Africa & Middle East Region http://www.vatame.org "Strength in Diversity" Link to comment Share on other sites More sharing options...
Diego Pedraglio Posted August 4, 2011 at 12:26 AM Posted August 4, 2011 at 12:26 AM I've merged all the models with the PA. I'm using the wilco flight dynamics and .cfg though, and only copied the [contact points] and [lights] section of the PA aircraft.cfg to the wilco aircraft.cfg Diego Pedraglio Link to comment Share on other sites More sharing options...
Mahmoud Fadli 819693 Posted August 4, 2011 at 06:19 AM Author Posted August 4, 2011 at 06:19 AM I've merged all the models with the PA. I'm using the wilco flight dynamics and .cfg though, and only copied the [contact points] and [lights] section of the PA aircraft.cfg to the wilco aircraft.cfg Would you mind sending me your A321 merge? Mahmoud A. Fadli - 819693 Deputy Region Director VATSIM Africa & Middle East Region http://www.vatame.org "Strength in Diversity" Link to comment Share on other sites More sharing options...
Mark Bennett 1041058 Posted September 5, 2011 at 11:16 PM Posted September 5, 2011 at 11:16 PM I've just managed to merge the Wilco A318 panel with the Wilco A319 as I prefer the LCD Screens but I keep getting a flap warning if I select flap 1 for takeoff. Is it possible to work around this? Link to comment Share on other sites More sharing options...
Recommended Posts