Maciej Olborski 1066926 Posted October 13, 2011 at 12:56 AM Posted October 13, 2011 at 12:56 AM Hello, I'm currently working on the Scottish Control pack which will be based on the Professional Mode etc. Everything is going okey but sometimes there is a problem with terminating aircrafts when they are cooming to land or leaving airspace to UNICOM. Funny thing is that sometimes it terminates aircraft propperly and sometimes it doesnt. So now the problem... When I do Uncorrelate aircraft and then release it, aircraft dissapears of my sector exit list and appears on my sector inbound list, it is perfectly fine if the aircraft is still in my airspace. But after aircraft leaves my airspace he should dissapear of my sector inbound list, sometimes it doesnt. The same problem appears when doing uncorrelate and then release to the aircrafts on a approach, they sometimes stay on my sector inbound list until pilot logoffs, they should stay only until pilot is airborne. I can provide you guys with settings etc, just tell me what you want to know Thanks in advence. Maciej. Link to comment Share on other sites More sharing options...
Johan Grauers Posted October 13, 2011 at 02:31 PM Posted October 13, 2011 at 02:31 PM Why do you uncorrelate them? Just because you drop them to unicom there's no need to remove the correlation, that is to be honest the easiest solution IMO. Johan Grauers Event Coordinator - vACC Scandinavia Link to comment Share on other sites More sharing options...
Michael Pike Posted October 13, 2011 at 11:12 PM Posted October 13, 2011 at 11:12 PM If you uncorrelate the tag, the aircraft position will be calculated from the flightplan and departure time. The "flightplan position" may still be in your airspace even though the radar echo you were following has left it. (Just thinking out loud). Mike Pike VATSIM-UK Link to comment Share on other sites More sharing options...
Recommended Posts