Michael Einar Reynis 11216 Posted June 18, 2014 at 06:24 AM Posted June 18, 2014 at 06:24 AM I have a new W7 32 Bit, freshly installed. Installed the latest version of ES 3.2. Logged in as Observer with rating of S2. The aircrafts are not showing up at gates but all at one single point on the runway, same goes for landing/landed aircrafts. Tried this only on EDDT until now. Windows redistributable for W7 32 Bit installed. Started with clean sector file. Any ideas that I might test? Thanks Michael Link to comment Share on other sites More sharing options...
Matthieu DELANEF 1138850 Posted June 18, 2014 at 04:06 PM Posted June 18, 2014 at 04:06 PM Did you check that you have correctly set your center of visibility ? .vis EDDT You can replace EDDT by any point or aircraft you want to. Deputy Director / Pilot Training Director VAT France - French vAcc Link to comment Share on other sites More sharing options...
Michael Einar Reynis 11216 Posted June 18, 2014 at 06:51 PM Author Posted June 18, 2014 at 06:51 PM Suddenly everything works again. Aircrafts starting at gates and landing normally. Case can be closed Regards Michael Link to comment Share on other sites More sharing options...
Matthias Schmitz 905157 Posted October 19, 2014 at 01:29 PM Posted October 19, 2014 at 01:29 PM I think I have exactly the same problem, but are unable to get rid of it. ES3.2 | Win7 64Bit The picture describes the problem. After ES3.2 run for several weeks without problems, now the Aircraft which are supposed to be at a gate at Frankfurt are displayed at one single spot bearing 263°/22nm from their parking position. When starting ES3.2 with a previous saved TWR-View, I have to recenter the picture, due the airport is somewhere else - while in normal scenario it is directly in the center of the screen. I run two PC : PC1 with one WIN7-setup and PC2 with two WIN7-setups chosen by the Bootmanager before booting. I have the problem on PC1 and PC2, but on PC2 only on one of the the two setups. So from three installations, I have the issue on two. Things I already tried: 1. Checked all data files, if they are corrupt-> OK 2. VOR position checked geographically -> OK 3. Stopwatch (Plugin) which did not run any longer deactivated (didn't caused any problems for weeks), now no failure m[Mod - Happy Thoughts]age any longer on start-up -> ok 4. Flightpaths are drawn from A/C to airport were they should be and from there on the shown routing is correct-> OK 5. Euroscope 3.2 completely de installed, deleted all entries in registry by hand, as far as I was finding them. Re installation from scratch: Same problem 6. VRC installed -> OK, no problem there 7. Router Update installed -> OK but no change to the problem 8. Loaded Simulated Traffic without being online before-> OK, all traffic is displayed were it is supposed to be 9. Euroscope 3.1d installed -> OK, works as it should I is not a simple offset, due all A/C at EDDF are displayed on one single spot with a range and distance simalar but not equal to A/C supposed to be a EDDL Rgds Matthias Schmitz Link to comment Share on other sites More sharing options...
Recommended Posts