Max Oyston 969671 Posted July 3, 2015 at 11:41 PM Posted July 3, 2015 at 11:41 PM (edited) Hi. Just recently installed VPILOT and think I did everything correctly, but when I try to connect to a sever none will connect. I have tried all the servers several times. Each time it comes up with an error message as follows: NETWORK ERROR. CONNECTION FAILED (10060). A CONNECTION ATTEMPT FAILED BECAUSE THE CONNECTED PARTY DID NOT PROPERLY RESPOND AFTER A PERIOD OF TIME, OR ESTABLISHED CONNECTION FAILED BECAUSE CONNECTED HOST HAS FAILED TO RESPOND. 106.186.24.200.6809. The only thing I can think of is that I did not put in a SELCAL code because I didn't know where to get it. Hope you can help!! Edited July 4, 2015 at 06:49 AM by Guest Link to comment Share on other sites More sharing options...
Richard Walsh Posted July 4, 2015 at 12:08 AM Posted July 4, 2015 at 12:08 AM SELCAL has nothing to do with it. You should post this in the VPilot form. From what I have read this is a firewall or porting issue. Link to comment Share on other sites More sharing options...
Max Oyston 969671 Posted July 4, 2015 at 12:40 AM Author Posted July 4, 2015 at 12:40 AM Thank you Richard Link to comment Share on other sites More sharing options...
Ernesto Alvarez 818262 Posted July 4, 2015 at 01:08 AM Posted July 4, 2015 at 01:08 AM I had this issue earlier today. was caused by my router. bad thunderstorms in the area at the time. all i had to do was unplug the router, wait 30 seconds, and plug it back in. thatll reset the router and you should be set Link to comment Share on other sites More sharing options...
Recommended Posts