Board of Governors Roger Curtiss Posted September 20, 2017 at 09:22 PM Board of Governors Posted September 20, 2017 at 09:22 PM Yesterday my Pro Pedals and TQ were working just fine running through a Belkin USB hub as they have for a few years. Today I installed a second monitor and in sorting out the cables I did unplug the hub. After plugging back in I found that the Pedals and TQ are no longer being recognized as being connected. I am also using a joystick (my CH Yoke recently stopped functioning properly after years of service) and the hub recognizes the stick. I also tried plugging the joystick, pedals and TQ directly to USB ports on the computer and again, the stick was recognized but not the CH products. I have tried numerous times plugging and re-plugging into various ports and combinations and restarting the computer (Windows 10) and I am out of ideas. Roger Curtiss VATGOV12 VP-Virtual Airlines & Special Ops r.curtiss(at)vatsim.net Link to comment Share on other sites More sharing options...
Scott Bickford Posted October 18, 2017 at 07:11 PM Posted October 18, 2017 at 07:11 PM I don't know if you fixed your problem, but I had similar strange issues and ran a usb cleaner then plugged things in one at a time. I don't remember which software I used, but it helped start over. Scott Bickford Link to comment Share on other sites More sharing options...
Board of Governors Roger Curtiss Posted October 18, 2017 at 07:18 PM Author Board of Governors Posted October 18, 2017 at 07:18 PM Well, the good news the hardware started working again. Bad news is I have no idea why. Roger Curtiss VATGOV12 VP-Virtual Airlines & Special Ops r.curtiss(at)vatsim.net Link to comment Share on other sites More sharing options...
Recommended Posts