Ray Trac 1397898 Posted January 21, 2018 at 10:59 PM Posted January 21, 2018 at 10:59 PM Greetings, Euroscope doesn't show up the display settings boxes to toggle what is displayed. If I disable one of the boxes, the box disappears! The VORs and Fixes and all that should be set up properly. Thanks in advance. Ray Trac Link to comment Share on other sites More sharing options...
Morten Jelle Posted January 24, 2018 at 07:52 PM Posted January 24, 2018 at 07:52 PM Hi Ray, I don't think it is setup correctly, because then I would have been shown. But have you entered this stuff in the ESE file or SCT file? If I remember correctly, this data comes from the ESE file. Morten Jelle VATSIM Network Supervisor, Team Lead - Supervisor Team 1 Link to comment Share on other sites More sharing options...
Ray Trac 1397898 Posted January 25, 2018 at 12:46 AM Author Posted January 25, 2018 at 12:46 AM Morten, It is all set up in the .sct file. I am 90% sure it goes in the .ese file. Sincerely, Ray Trac Ray Trac Link to comment Share on other sites More sharing options...
Morten Jelle Posted January 26, 2018 at 11:15 PM Posted January 26, 2018 at 11:15 PM Just to be sure, it is not automatically going into the ESE file. So if it isn't in the ESE file, it must be entered into that one. Morten Jelle VATSIM Network Supervisor, Team Lead - Supervisor Team 1 Link to comment Share on other sites More sharing options...
Ray Trac 1397898 Posted January 27, 2018 at 02:50 AM Author Posted January 27, 2018 at 02:50 AM Morten, It should be going to the ese file. I can see the things if I go and edit the profile display settings to show a group. I just don’t want to type every single item to be displayed. Sincerely, Ray Trac Ray Trac Link to comment Share on other sites More sharing options...
Recommended Posts