Board of Governors Roger Curtiss Posted February 24, 2018 at 04:52 PM Board of Governors Posted February 24, 2018 at 04:52 PM I am pairing a double unit of Saitek TQs with a registered version of FSUIPC4. I have read the FSUIPC instructions on calibrating and tried a few times to get things properly calibrated, however my results are always the same- the two throttle axes respond with full range of thrust but this band is in the upper half of the lever range-reverse engages well above the detent for idle. The lever I have for flaps is pretty much the same way-full range of flap positions but this not begin to respond until halfway through the lever range. Wondering if anyone else has experienced this situation and/or can offer up a way to overcome this difficulty. Thanks Roger Curtiss VATGOV12 VP-Virtual Airlines & Special Ops r.curtiss(at)vatsim.net Link to comment Share on other sites More sharing options...
Recommended Posts