Slavenko Rojas 1466777 Posted November 4, 2019 at 11:04 PM Posted November 4, 2019 at 11:04 PM hey guys !! im sorry for doing a new post but this is already frustrating. Im using x pilot 3, but sometime x pilot no work the TX (its off) or voice no work, others pilot or towers can not hear me, i dont know the reason, there are not change on the radio or the setting, everything is same. ive installed / and updated /the micro and setting is checked/working on my pc I have a ffa320 on X plane 11/I have x pilot 1.1.3.0 Can you help me? https://www.dropbox.com/s/o9bcghlaaidn75z/1.PNG?dl=0 Slavenko. Link to comment Share on other sites More sharing options...
Justin Shannon Posted November 5, 2019 at 01:20 AM Posted November 5, 2019 at 01:20 AM In version 1.1.3.0 I added two dot commands that you can use to force the TX and RX state for aircraft that don’t use the standard datarefs. Take a look at the dot command section in the docs on how to use them: http://xpilot.clowd.io/docs Controller (C3), Los Angeles ARTCC Developer: xPilot, vATIS Link to comment Share on other sites More sharing options...
Slavenko Rojas 1466777 Posted November 5, 2019 at 08:02 PM Author Posted November 5, 2019 at 08:02 PM In version 1.1.3.0 I added two dot commands that you can use to force the TX and RX state for aircraft that don’t use the standard datarefs. Take a look at the dot command section in the docs on how to use them: http://xpilot.clowd.io/docs Hey Justin, trank you for your reply, i found two commands (im sorry im noob yet on vatsim) those are: .rx com# on|off Toggles receiving on the specified com radio. For example: .rx com1 on .tx com# Enables the COM1 or COM2 radio for transmit. For example: .tx com2 are these ? If this is the case, let me try this commands and i will confirm you fir here (today i installed xpilot and it works with TX) Again I appreciate your reply . Slavenko. Link to comment Share on other sites More sharing options...
Justin Shannon Posted November 5, 2019 at 08:11 PM Posted November 5, 2019 at 08:11 PM In version 1.1.3.0 I added two dot commands that you can use to force the TX and RX state for aircraft that don’t use the standard datarefs. Take a look at the dot command section in the docs on how to use them: http://xpilot.clowd.io/docs Hey Justin, trank you for your reply, i found two commands (im sorry im noob yet on vatsim) those are: .rx com# on|off Toggles receiving on the specified com radio. For example: .rx com1 on .tx com# Enables the COM1 or COM2 radio for transmit. For example: .tx com2 are these ? If this is the case, let me try this commands and i will confirm you fir here (today i installed xpilot and it works with TX) Again I appreciate your reply . Slavenko. Yes, those are the ones. Controller (C3), Los Angeles ARTCC Developer: xPilot, vATIS Link to comment Share on other sites More sharing options...
Recommended Posts