Clemens Martin Posted January 8, 2020 at 09:35 PM Posted January 8, 2020 at 09:35 PM Hey there, after updating to 1.1.9.1 i didnt have any voice or text on COM1 with ATC. Tried several things but finally these steps did the trick: 1. .rx com2 on (switch RX to COM2) 2. .tx com2 (switch active TX to COM2) 3. switch the ATC frequency on COM2, check in with radio check 4. back to COM2 unicom (122.80) (for later standby) 4a. .rx com2 off (dont get annoyed by unicom calls on COM2 when on active COM1) 5. .rx com1 on (switch RX to COM1) 6. .tx com1 (switch active TX to COM1) 7. rejoin COM1 frequency as usual and do a radio check Cheerz, Clem Link to comment Share on other sites More sharing options...
Justin Shannon Posted January 10, 2020 at 01:46 AM Posted January 10, 2020 at 01:46 AM If the aircraft model you're flying doesn't use the standard datarefs, you will need to use the .rx and .tx commands to enable/disable the appropriate com radios. Controller (C3), Los Angeles ARTCC Developer: xPilot, vATIS Link to comment Share on other sites More sharing options...
Clemens Martin Posted January 10, 2020 at 07:37 PM Author Posted January 10, 2020 at 07:37 PM Ok, to shorten the procedure: 1. .rx com1 on 2. .tx com1 thats enough, and yeah it's non default datarefs in the flight factor B752v2. Cheerz Link to comment Share on other sites More sharing options...
Recommended Posts