Grant Williams Posted September 18, 2020 at 10:37 PM Posted September 18, 2020 at 10:37 PM Hello, Yesterday I loaded into Boston Logan for a flight to Bermuda. I connected to the network through xPilot as I always have (see screenshots for settings). I tuned 121.9 for clearance. When I keyed up my mic, the Rx button illuminated. I noticed the Rx button was grey. I checked that my mic was working through xPilot, and it was. I used the .wallop command because after a few transmissions I thought I was being ignored. It would not allow me to wallop. I then sent a PM to ground who said he could not hear me. I noticed other aircraft moving on the deck and realized I wasn't hearing anything either. It was very odd and I am truly unsure of what to do. I tried restarting xPilot and my computer, alas it did not solve the issue. Any thoughts are welcome. Thank you! Link to comment Share on other sites More sharing options...
Mats Edvin Aaro Posted September 18, 2020 at 11:11 PM Posted September 18, 2020 at 11:11 PM Can you show us the radio stack in the airplane, are you sure you had enabled COM1 receive in the Audio Control Panel? Some planes simulate this, and you need to manually push in and/or twist the knob clockwise to recieve radio signals. This is indicated by the currently greyed out "RX" button turning white. As for the wallop problem, what exactly did you type? It looks like you didn't write anything after. A wallop should include the phrase ".wallop", but also a brief description of the problem. If you don't write anything after the actual phrase, you will get an error like that. 🙂 Mats Edvin AarøAssistant to the Vice President - Supervisors VATSIM General Manager: Member Engagement[email protected] Link to comment Share on other sites More sharing options...
Recommended Posts