Board of Governors Roger Curtiss Posted November 14, 2020 at 08:05 PM Board of Governors Posted November 14, 2020 at 08:05 PM X-Pilot recognizes what frequencies I have tuned on COMM1 and COMM2 with all the aircraft in my hangar except for the SSG E Jets 170/195. Those used to work just fine but recently their radio selections do not populate to X Pilot and therefore radios do not connect to the network with these aircraft. I suspect it is an SSG problem but have had no success tracking down a solution with that so am posting here to see if anyone has had a similar problem with SSG or other products. Roger Curtiss VATGOV12 VP-Virtual Airlines & Special Ops r.curtiss(at)vatsim.net Link to comment Share on other sites More sharing options...
Justin Shannon Posted November 15, 2020 at 04:33 AM Posted November 15, 2020 at 04:33 AM Unfortunately, not all aircraft developers consistently use the same datarefs to control radios — many actually create their own datarefs! As a workaround, you can force xPilot to activate TX/RX. See the "Dot Commands" section in the documentation: https://docs.xpilot-project.org/#/user-guide Controller (C3), Los Angeles ARTCC Developer: xPilot, vATIS Link to comment Share on other sites More sharing options...
Board of Governors Roger Curtiss Posted December 1, 2020 at 04:33 AM Author Board of Governors Posted December 1, 2020 at 04:33 AM In this instance the situation was resolved by updating to the v 1.5 of the Ejets from v 1.4. Roger Curtiss VATGOV12 VP-Virtual Airlines & Special Ops r.curtiss(at)vatsim.net Link to comment Share on other sites More sharing options...
Recommended Posts