Dan Anziano Posted December 11, 2020 at 04:12 PM Posted December 11, 2020 at 04:12 PM Hello all! Brand new to VATSIM and I'm trying to have an observe only session using vPilot. I seem to connect ok, I'm parked at a gate on the airport and can see ATIS as well as Center coms but when I attempt to set the correct frequency for either my radio instantly kicks back to the current frequency. I'm in TBM930. I do get a brief second where I can hear ATIS before switching back to the original frequency but nothing at all for Center. Any help appreciated as I simply want to get some observation time before going any further. Link to comment Share on other sites More sharing options...
Mats Edvin Aaro Posted December 11, 2020 at 04:46 PM Posted December 11, 2020 at 04:46 PM Hi! Are you using MSFS by any chance? This is a known issue using in-game ATC. Don't use that when using VATSIM, there might also be some additional settings but I'm not sure. 🙂 1 Mats Edvin AarøAssistant to the Vice President - Supervisors VATSIM General Manager: Member Engagement[email protected] Link to comment Share on other sites More sharing options...
Dan Anziano Posted December 11, 2020 at 06:31 PM Author Posted December 11, 2020 at 06:31 PM Oh, yes sorry Mats, on MSFS. Thanks for the reply. I will start with your suggestion. BTW I did try it in the Beechcraft King Air with better results but you are correct as the in game ATC was stepping on the ATIS. Thanks again, Dan Link to comment Share on other sites More sharing options...
Recommended Posts