Robert Vanderkam 1 Posted December 16, 2020 Share Posted December 16, 2020 I'm just trying to get vPilot set up for FS2020 and I'm having trouble getting connected. It says it needs a flight plan "loaded" before it will connect me to the sim, but I read that I cannot load a flight plan until I'm connected. I seem to be stuck. Rob Vanderkam Canadian Virtual Airlines (CVA) - in operation since 1997 Link to post Share on other sites
Board of Governors Matthew Bartels 74 Posted December 16, 2020 Board of Governors Share Posted December 16, 2020 I think you may be confusing flight plan with flight. Make sure that the simulator is fully loaded and you are at the gate before you connect. Not at any of the menus. 1 Matt BartelsVP: Marketing & Communication vpmkt (at) vatsim.net Unless otherwise stated, opinions are my own and not representative of the official opinion of the VATSIM Board of Governors Link to post Share on other sites
Paul Moxhay 1 Posted December 16, 2020 Share Posted December 16, 2020 It says you have to have a "flight" loaded... that is a little misleading as you don't really "load" a flight into the flight sim. What it means is that you have started the flight and are at the gate. Just a small reminder... once you have connected, don't forget to take a peek outside the aircraft to make sure you haven't spawned on top of another aircraft already at the gate. If you have, just disconnect and move to another gate either by slew or relocate via the sim menu to start a new flight. Hope that helps 🙂 1 Link to post Share on other sites
Robert Vanderkam 1 Posted December 16, 2020 Author Share Posted December 16, 2020 Thanks both of you. And yes, I'm an old hand at VATSIM from FSX days but not since 2012 or so and using squawkbox I think. Cheers Rob Vanderkam Canadian Virtual Airlines (CVA) - in operation since 1997 Link to post Share on other sites
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now