Krzysztof Cegielkowski Posted December 25, 2020 at 02:30 AM Posted December 25, 2020 at 02:30 AM Hello, I installed today Prepar3D v5.1 and on antoher computer vPilot via simconnect. I try to use FLAi models. Simconnect is configured properly. vPilot see my Prepar 3D it seems that vPilot just dont see my aircraft models. When I try to connect I get strange error: "[02:21:11] Cannot connect to the network. The active simulator was not found when vPilot scanned your hard drive for available aircraft models. You will need to repair your simulator installation before using vPilot with this simulator." I selected custom rule for FLAi Model Matching. Could you help me please? Regards, Chris Link to comment Share on other sites More sharing options...
Ross Carlson Posted December 25, 2020 at 03:01 AM Posted December 25, 2020 at 03:01 AM You need to run vPilot on the same computer as the sim. If you want the vPilot main user interface on a separate computer, then you can run it in split Host/Remote mode. There are instructions in the documentation. Developer: vPilot, VRC, vSTARS, vERAM, VAT-Spy Senior Controller, Boston Virtual ARTCC Link to comment Share on other sites More sharing options...
Recommended Posts