Fatmir Jusufi 1001462 Posted October 27, 2008 at 06:36 PM Posted October 27, 2008 at 06:36 PM Hi all, I have just built up my new own hardware and after truning on, gives me a strange error usb device over current status detected!! shutting down in 15 seconds Not able to enter in BIOS or something else. I have also looked for jumpers and CMOS but till now it's the same problem. Mobo ASUS P5QLE-M Really appreciate your help. Regards, Fatmir Fatmir Jusufi 1001462 Link to comment Share on other sites More sharing options...
Garry Morris 920567 Posted October 27, 2008 at 07:12 PM Posted October 27, 2008 at 07:12 PM I haven't seen this error before, but it sounds to me like you have a hot power cable plugged into a USB cable jack on the motherboard, or something else is cross/miswired/plugged in backwards. Stop immediately, unplug the machine, and go recheck every last connection you put onto that board against the instruction manual to avoid potential damage to the board or components. http://www.execjetva.com Link to comment Share on other sites More sharing options...
Fatmir Jusufi 1001462 Posted October 27, 2008 at 11:10 PM Author Posted October 27, 2008 at 11:10 PM Now problem solved! After 12hrs! :D Fatmir Jusufi 1001462 Link to comment Share on other sites More sharing options...
Garry Morris 920567 Posted October 28, 2008 at 12:17 AM Posted October 28, 2008 at 12:17 AM In case someone has the same problem in the future and finds this thread, would you mind posting how you fixed it? http://www.execjetva.com Link to comment Share on other sites More sharing options...
Fatmir Jusufi 1001462 Posted October 28, 2008 at 12:09 PM Author Posted October 28, 2008 at 12:09 PM Unfortunately there were some mine amateur mistakes during mobo fixing!! This was the only problem! Fatmir Jusufi 1001462 Link to comment Share on other sites More sharing options...
Garry Morris 920567 Posted October 28, 2008 at 04:24 PM Posted October 28, 2008 at 04:24 PM It happens. Luckily your board protected itself. To folks building their own machines - be VERY careful where all the wires go. Hooking up one incorrectly can result in frying your brand new board or yourself. http://www.execjetva.com Link to comment Share on other sites More sharing options...
Recommended Posts