Jonas Eberle Posted May 7, 2009 at 03:16 PM Posted May 7, 2009 at 03:16 PM When the primary connection is lost (either by disconnecting manually or accidently), reconnecting the ATIS will set 199.998 as its frequency. Can be circomevented by disconnecting the ATIS and connecting the ATIS again. That should go to Mantis but I cannot reach it and I do not have a login yet. Link to comment Share on other sites More sharing options...
Todor Atanasov 878664 Posted May 7, 2009 at 05:24 PM Posted May 7, 2009 at 05:24 PM Just test it and the ATIS is setting it's correct freq. Does the ATIS connection disconnect on prim. disconnection? Is this happening all the time? What ES version do you use? EuroScope BETA Tester/Board of Designers Link to comment Share on other sites More sharing options...
Jonas Eberle Posted May 13, 2009 at 03:22 PM Author Posted May 13, 2009 at 03:22 PM I find it reproducable in my setup: ES 3.0a When prim. connection is disconnected, ATIS disconnects also. The voice dialog shows still "ATIS", "RCV Voice" + "TX Voice" checked. On reconnecting the prim. frequency, ATIS remains unconnected and no changes in Voice setup dialog. Then I reconnect the ATIS (multiple record playback still running) - ATIS frequency changes to 199.998. Disconnect the ATIS, reconnect the ATIS again: all fine Just a minor flaw that happened to be discovered when I got disconnected from the network and did not thoroughly check that the ATIS reconnects properly. Just a bit awkward... Link to comment Share on other sites More sharing options...
Recommended Posts